Summers Superchisel - 3-Section Manual de usuario descargar pdf (Pagina 74)

3-8

SECTION 3 – CHISEL PLOW OPERATION

5. Leveling chisel plow from side to side. Stop tractor with machine in the ground. Check depth of

tillage on the left wing, center, and right wing. If leveling is necessary, use wrenches provided to

adjust eyebolts on cylinder attachments located at rear of chisel plow.

*NOTE: Insure that cylinder attach holes are aligned when eyebolts are tightened.

One turn of 1-1/2” NC Cylinder Attach Eyebolt Nut changes chisel height 3/8”. One inch of cylinder

stroke moves chisel plow height over 2 inches. Therefore, it may only be necessary to move eyebolts

a small amount to attain correct adjustment of each section.

IMPORTANT!

Pressure must be removed from cylinders before adjusting eyebolts. Rest chisel plow on

top of the ground, shut tractor off and relieve pressure by cycling remote lever.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 137 138

Sin comentarios

Summers Superchisel - 3-Section Manual de usuario Pagina 74