Summers Superchisel - 3-Section Manual de usuario descargar pdf (Pagina 64)

2-52

SECTION 2 – HYDRAULIC SET-UP (32’-44’)

6. Charge Wing Lift Cylinders.

– Block rod end of cylinders so cylinders can extend without hitting anything.

– Fully cycle the cylinders several times to make sure that all air has been removed from sys-

tem.

– Leave cylinders in fully extended position.

7. Connect rod end of cylinders to wing. Follow these steps and see drawing below.

– Use pivot bolt, washers with collars, 1-1/4” washers, 1” washer and 1” lock nut provided.

– 1-1/4” washers must slide freely inside wing amecuts.

– Do not over tighten lock nut. Pivot bolt must rotate freely.

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 137 138

Sin comentarios

Summers Superchisel - 3-Section Manual de usuario Pagina 64