Summers Superchisel - 3-Section Manual de usuario descargar pdf (Pagina 72)

3-6

SECTION 3 – CHISEL PLOW OPERATION

FIELD OPERATION

1. Rephase cylinders before starting eld operation.

2. Choose a at spot in a eld to set tillage depth and level chisel plow.

3. Determine desired tillage depth by working test strips within the eld.

IMPORTANT!

The operator is responsible for adjusting machine since machine does not come “Field

Ready” from factory.

NOTE: Optimum performance of machine is achieved by tilling at a depth and moving at a

speed that does not go beyond limit of trip assemblies. This limit is exceeded if connecting

bolt (shown in the following drawing) continually rides above trip assembly cap.

IMPORTANT

TO REPHASE CYLINDERS, RAISE

MACHINE AND MAINTAIN HYDRAULIC

PRESSURE TEN SECONDS AFTER

CYLINDERS ARE FULLY EXTENDED.

QUICKLY RETRACT CYLINDERS AT

LEAST 1/2”. REPHASING SHOULD BE

DONE EVERY HOUR OF OPERATION TO

MAINTAIN UNIFORM TILLAGE DEPTH.

8Z0340

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 137 138

Sin comentarios

Summers Superchisel - 3-Section Manual de usuario Pagina 72