Summers Disk-Chisel Manual de usuario descargar pdf (Pagina 52)

GANG-SCRAPERS

8/28/2007

9CC3612.iam/

8J0190

8K4200

8K4210

8CC1000

8T4100

8CC1020

8J3246 - 46"

8J3256 - 56"

8J3266 - 66"

8J3276 - 76"

8J3286 - 86"

8CC1152

8K3002

8K4420

2-40

SECTION 2 – INSTALLATION OF SHANKS AND COULTER GANGS

1. Gang Mounting – Start from the center and work towards the outside when hanging the gangs.

Bearing location is important, use correct gang assembly for each location. Carefully lift gang to

frame close to correct location. Attach C-shanks to frame using (2) 3/4” U-bolts, mounting plate

with peg, ﬂ at mounting plate, lockwashers and nuts. After both C- shanks on each gang are

mounted, slide the gang to its proper location and tighten hardware.

2. Scraper Mounting – Attach scraper mounting tubes to scraper support brackets (8J0200) using

3/4” U-bolts (8K5505), spacer ﬂ at (8K4420), lockwashers and nuts. Attach scraper ﬂ ats (8J0190)

to the mounting tubes using 3/4” U-bolts (8K5505), ﬂ atwashers (lower hole only), lockwashers

and nuts. Center between coulter blades.

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 118 119

Sin comentarios

Summers Disk-Chisel Manual de usuario Pagina 52