Summers Disk-Chisel Manual de usuario descargar pdf (Pagina 40)

2-28

SECTION 2 – HYDRAULIC SET-UP (32’-40’)

1. Hydraulic hoses and ﬁ ttings for depth control cylinders can be found on following drawing.

– Rephasing cylinders require that oil from the rod end of ﬁ rst cylinder goes to base end of

second cylinder and so forth. Cylinders will not operate properly unless they are connected

correctly.

2. Special attention should be paid to routing of hydraulic hoses. Diagrahm below shows layout of

hoses for depth control cylinders.

A. It is best to start by routing the hose for the 6 x 10” cylinder. Make sure there is 60” of hose

ahead of hose holder. This is usually enough hose for safe and easy hook-up to tractor.

B. Route hose along hitch frame. Use plastic clamps provided. Do not tighten until routing is

complete.

– Clamps are made to have the round surface point towards the surface that you are

mounting to. DO NOT OVER TIGHTEN.

C. Leave slack by hitch pivot.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 118 119

Sin comentarios

Summers Disk-Chisel Manual de usuario Pagina 40